How to install the inlet - outlet fittings kit on the DualQuickfit hydraulic links?

1. Pressurized system

A kit of brass inlet / outlet fittings is used to connect the inter-panel links to the transfer circuit.

• M3/4’’ for DN15 inter-panel links
• M1’’ for DN26 inter-panel links

This kit includes, for a line of panels: 2 corrugated fittings 4 hose clamps 2 high temperature fiber O-rings 2 screw caps

These fittings are installed at the inlet and outlet of each line of sensors.

Assembly of the clamp:

• Place the clamp on the hose 
• Insert the barbed fitting into the hose (1 & 3)
• Tighten up to the stop (2 & 4)
  <!> Do not squeeze any tighter

The inlet / outlet fitting kit is to be installed as specified below:

Simplified diagram installation of a hydraulic line with 4 panels in portrait

Simplified diagram installation of a hydraulic line of 2 panels in landscape

The fluid must flow from bottom to top in the panels.

Respect the hydraulic connection direction (3) at the inlet (1) and at the outlet (2), as shown in the diagrams above and in the table below.

2. Pool system

A kit of compression inlet / outlet fittings for the DN26 inter-panel links allows the inter-panel links to be connected to the transfer circuit.

This kit includes, for a line of panels: 2 x D32/40 mm compression fittings 2 x D32 mm compression caps

These fittings are installed at the inlet and outlet of each line of panels.

The inlet / outlet fitting kit is to be installed as specified below:

Simplified diagram installation of a hydraulic line with 4 panels in portrait

To authorize the winter draining of the direct pool heating system, the DualSun SPRING panels must imperatively be installed in portrait. The fluid must flow from bottom to top in the panels.

Respect the hydraulic connection direction (3) at the inlet (1) and at the outlet (2), as shown in the diagrams above and in the table below.

For more information, click here : How do DualQuickFit interpanel connectors work?